Question

Does wire A16 (purple/yellow) need to be tapped into wire A10 (lt. blue/black) 2013 Infiniti G37 sedan/evo-nist1?

The wiring diagram for a 2013 Infiniti G37 sedan, using an EVO-NIST1 shows that the A16 (purple/yellow) wire needs to be tapped into A10 (lt. blue/black) wire. 

Im trying to see if this in necessary because both wires are attached to the same connecter. Furthermore, none of the install videos I have found for this set up and vehicle have mentioned connecting these wires to one another. What will happen if it is not connected?

Answer 1

Hello,

Yes both wires must be spliced onto the lt.blue/black of the t-harness. It is mandatory.

If it is not connected you may get intermitent remote starting. In some cases it may also hinder in vehicle programming.

Best regards.

Comments

Two wires need to be spliced onto A10 (the lt. blue/black wire)? My diagram only shows one, A16 (the purple/yellow wire).

What other wire am I missing?

---

lt.blue/black and purple/yellow from the 20 pin connector both go to the loose lt.blueblack wire coming out of the t-harness