How to wire CAN to EVO-ALL Mustang 2013

Question

Hi, I have an EVO-ALL + THAR-FORD1 harness. I believe I have all of the required connections except for the two CAN wires. Where can I buy the required connectors to feed the CAN wires into the white terminal in the EVO-ALL? I was planning to T-tap the wires off of the ODB2, but how can I connect it on the EVO-ALL side?

Answer 1

Hi, there are no connectors made specifically for the CAN wires. They have to be connected wire to wire. The recommended way to attach the wires would be a T-Splice, you can solder the wires and/or tape them after to strenghten the connection.

Comments

Tapping into the wires is straightforward, but how can I connect these to the Evo?

Answer 2

Your evo-all should have come with a white 5 pin connector. Has a grey and grey/black wire in it, youll need those.  

 

Manually strip the vehicles wire at the OBDII connector and splice it into the vehicle wire.

Comments

It did not come with this connector; I've read conflicting comments on whether it should. Are they available separately?

---

No they are not, I would suggest contacting your point of purhcase in regards to a replacement.