Questions & Answers

2018 Subaru Push to Start attemts to start but no cranking

0 votes
I have installed and programmed the Evo ONE module on 2018 Subaru Outback Push to Start. The module have been programmed and dycrypted when everything is connected, and 3xlock button is pressed on the remote, the car tries to start 2 times, but there is no cracnking sound on the engine. Please help
closed with the note: Got resolved though trouble shooting of wires.
asked Dec 12, 2020 in Subaru by Viktor Ryzhykh (370 points)
closed Jan 3, 2021 by Viktor Ryzhykh

1 Answer

0 votes
Verify that the light blue/black is not on the wrong side of the cut immobilizer wire.
answered Dec 12, 2020 by Robert T (297,620 points)
Thanks for answerring. I have checked the wire LightBlueBlack is Connected WIth YellowGreen and connected to RedWithe which is taking place to the origin of wire  The YellowRed is connected to the RedWhite and is connected to the wire harness/connector head.

   P.S. I have also tested the voltage from the root wire and the end(connector), on both sides Immo wire puts out 10.89 Volts.

Another thing I have tried to get the voltage reading oin the Yellow(+Starter) Evo Module wire and it is not giving me any readig (0 V), and the main harness WiteGreen(on the green socket Pin34) isn't giving any voltage reading either, is it supposed to be 12V, when the car attempts to start the wire give 12V. any clues? Thanks.
Everything got solved after I have reconnected the cable (red)-gray/black(evon one) from the push to start button.

P..S. it would also help if the installation guide will give amount of amps needed to be present in the wire. Thanks.
...