Questions & Answers

R Link module connection

0 votes
I have download the the instructions for the EVO-VWT1 with T-harness. I have updated both the flash link updater and EVO as a standalone. Looking at the instructions, I don't see where the hi and low can bus wires are used. It also does not say how to connect and program the R-Link module. The instructions said need the following connections: yellow (power), yellow/red (brake) and the two wrap wires ((white/red and white/blue. Am I missing anything else?
asked Mar 12, 2021 in Audi by rrobin2569 (130 points)

1 Answer

0 votes

The r link plugs into were the tb-vw goes. Once programming is finished you remove the r link and plug back in the tb-vw and that stays in the vehicle and you keep the r-link for the next vw/audi vehicle.

 
 

 
The following wires must be manually connected:
 
1- start/stop
2- transponder interrupt
3- can wires
4- brake wire
 
The hazard light connection is optional. 
 
answered Mar 12, 2021 by derek g (324,940 points)
...