Questions & Answers

HEADLIGHTS FLASHING when entering vehicle AFTER 3xstart and 15min run time is met

0 votes
2016 kia sedona ex push to start

t-harness

When entering the vehicle after using 3xstart and 15 min run time ends- OR starting using push to start button- the vehicle is flashing headlights/tails only. Vehicle will start- but the headlight indicator on insturment cluster lights in unison with the headlights/tails. The vehicle will start and have no flashing lights using the 3x press on remote.

Is there a toggle that is active that should not be?

I am current on software version. I did need to toggle 3x press on so the vehcle would use remote - folliwin the installation instructions .
asked Dec 1, 2021 in Kia by Eric Romine (130 points)

1 Answer

0 votes
What is the 12 digit service number (s/n) of the module?

At step 5 programming, while the BLUE LED is flashing, is the RED LED on solid?
answered Dec 1, 2021 by Robert T (297,620 points)
I will look- vehicle is in owner possesion. I am at another job until 4pm.

As I recall the blue light flashed but red was NOT on solid- flashed rapidly 6 or 10 times and then blue comm light was flashing and done.
UPDATE-

T harness THAR-ONE-KHY8 was used for install

Step 5 DID have red lamp rapid flash , followed by blue flash- , then one push of the push-to-start to turn off vehicle.

3x remote lock functioned normally.

The hood pin feature is NOT installed- and the toggle A11 was turned to off.

Valet button is also NOT installed.

 

Vehicle operates correctly
12 digit is 002B0222908
Turn 14.1 on instead of 14.2 and see if the light flash persists
...