Questions & Answers

Why is Yellow light on module is not coming on when ignition is on?

0 votes
2006 4runner. Evo was successfully updated with the firmware updater. Wires were ran as per the diagram on Evo one module was successfully program (10x red light flashes). When I turn the ignition on to program the Carlink rf kit the yellow light on the Evo one does not light up when I turn the key to that position. I unplugged the main 6pin harness and checked for 12v on the big pink wire (good). I traced back all the wires and they are all connected per the diagram. Also the main 6 pin harness is the plug and play harness Toy1 t-harness.
asked 3 days ago in Toyota by Jose Quinones (200 points)

1 Answer

+2 votes
Best answer

yellow will not turn on when CAN-BUS is not programmed, it is normal you will not see it since the module is not connected to CAN on this vehicle.


To program your carlink,

1- make sure to follow their instructions on how to connect it to the EVO using their own HRN-LLRS-01 harness

2- setup the app for fortin

3- follow programming in car


Following the RED LED on the BACK of the unit, not the one on top.

  1. Igniton ON-OFF-ON  (red led on evo will turn on solid)
  2. Hit brake 4 times (red led will flash on each brake press)
  3. At this point wait 10 seconds then shut off the car.
answered 3 days ago by Robert T (271,890 points)
selected 3 hours ago by Derek
After applying your comments. The carlink and module are functioning well. Thanks