Questions & Answers

Dodge Journey problem

0 votes
We did the install of a evo unit 001A07 256829 with THAR-CHR7 for a 2012 Dodge Journey as per instructions .

The remote start works but we can't stop the car until the unit is disconnected , we think there's a problem with the unit receiving a brake signal .

Should we remove the obd2 harness and directly splice onto the canbus wiring or could there be an error in the flashing , key programming or decryptor process ?

Thanks
asked 1 week ago in Dodge by Maxime-Pierre Belasky (130 points)

1 Answer

+1 vote
check if the option A7 is on.

Normally brake is monitored through Can bus or Turn off A7 and connect the black wire on the 20 pin connector to the positive brake wire.
answered 1 week ago by Haidar Jabbar (16,680 points)
...