Questions & Answers

2015 Subaru Crosstrek XV. DCRYPTOR process produces solid red and blue status lights

0 votes
Have checked wiring all is good. Just goes from flashing red blue to solid red blue as soon as I turn on the ignition to program the DCRYPTOR.
asked Apr 9, 2022 in Subaru by Scott Hodgson (130 points)

1 Answer

0 votes
What is the S/N number on the back of the module in question?
answered Apr 11, 2022 by derek g (324,940 points)
T harness
To add if I press the clutch during remote start it will start and shut down in a couple seconds. But starts.
When you try to remote starter it, test the vehicles 2 starter wires and tell me what readings you are getting. be sure to test it at the OEm connector, this way we will see if the voltage is passing through the t-harness.
So I now can start the the car remotely. I changed the location of the BLU Black IMO wire and now it starts. However it does not seem to be sending the clutch info asIstillneedto holdtheclutch in. Checked clutch wire and it is connected correctly
If you press the clutch in and it remote starts, this confirms something is wrong with the clutch connection/wire.

 

I would test both the output of the module and the wire you are connected to as well.
...