Can't get into remote start mode in Flash-Link

Question

Evo-All with GM V2 harness for 2011 Camaro SS. The Flash Link software will let me into the bypass settings but I cannot get into the remote start settings. It tells me that the unit is disconnected. I tried using the "special unit" and have had no luck.

Also, when I programmed it, the finally step didn't seem to complete and I have a continuous blue light on the unit. Does that mean that my CAN wire isn't getting a good signal?

Answer 1

First things first, you should only be in "connection mode:BYPASS"

Second thing, you need to update the unit after doing decrypting, please click on "automatically update unit"

do those things first and then try it in the vehicle.

Comments

Let's rewind. I reset the unit today and during the key sequence on the initial programming the red light flashes once, turn key off, remove, turn key back on, red light flashes, yellow light flashes, they all shut off and no blue light ever comes on until I turn the ignition off.

Called tech support today and he said to check my fuses under the hood. I checked and they are all fine.