Questions & Answers

EVO-ONE with THAR-GM6

0 votes
Guide # 77191

REV.: 20200407

2019 GMC Yukon – Push Button Start

EVO-ONE with THAR-GM6

 

 

 

1) Guide calls out D6 as White/Red.  My T-Harness wire color is Blue/Black.  Is this a problem?

 

2) Guide says to isolate wires D1 and D3 at the T-Harness connection.  However, these wires terminate at BCM X2 (blue) pin 17.  D1 terminates at the BCM side and D3 terminates at the truck side.  Isolating the T-Harness wires would permanently disable this BCM circuit. Please confirm if the wires require isolating.

 

3) Guide calls out A3 as Purple/White.  My T-Harness wire color is Purple/Black.  Is this a problem?

 

4) The Guide says to install a hood pin.  However, there doesn’t seem to be a provision to wire it up to the module.
asked Aug 22, 2020 in GMC by David Jax (130 points)

1 Answer

0 votes
1- No

2- Just isolate the yellow/blue(d2) and white/blue(d5) wires that should be loose.

3- No

4- Hood/Door pin input is the Pink/Black on the 20 pin connector which should already run into the harness for you.

 

Thank you for the feedback, I will forward it to our graphics department to have the guide wire colors updated.
answered Aug 24, 2020 by derek g (324,940 points)
...