How to activate Evo All Alarm on a 2019 nissan qashai

Question

I have successfully installed Evo All as a standlone setup with a T harness on 2019 nissan qashai with push to start I donot have a factory alarm installed I only have factory horn 1x chirp after lock from oem remote and no chirps for the unlock I searched and found that pin A4 in the evo ( green ) should go to the horn signal and to enable options G in the evo I see from my car guide that pin A4 is already in use for the Ignition so i cannot figure it out how the evo can control the horn I have enabled options G and nothing happened ( expected ) Please advise how can i add the evo alarm features to my current setup My evo s/n : 001A07026604

Answer 1

Unfortunately, on certain  nissan vehicles we have to use the wires that are used for the evo-alarm features for remote starting features. so in that particular vehicle you cannot have horn and starter kill outputs. (white and green wires)

 

Installing an EVO-ONE module will let you enable evo-alarm as the Evo-One has a dedicated horn/siren output wire.

Horn honk and/or siren chirp on first lock or unlock will only be available with an aftermarket RF kit,  as we mimic the oem remote when it's used to control the Evo systems.

Comments

Thx for your answer So what is the cheapest 2 way RF kit avialable as i saw a lot of RF kits and the installation guide so i can enable the alarm feature using horn in my nissan qashqai

---

In order to ubderstand correctly, i must have evo one so i can have control over the horn in my nissan qashqai ? Or i can have control on the horn if i added let's say rf kit rfk411 to the current evo all that i already have in place ?