Questions & Answers

2015 crosstrek program OEM RF transmitter lo enable 3x start.

0 votes

 

2015 CROOSTREK WONT REMOTE START. HOW DO I PROGRAM OEM RF TRANSMITTERS TO REMOTLY START VEHICLE.

I FOUND THIS TROUBLESHOTING THE EVO-ONE. 

DECRYPTOR DONE AND UPDATED , INSTALLED BACK TO CAR BUT DOESNT REMOTE START WITH 3X LOCK)

If the red led is not turning on then the module is not receiving a start command. Verify that the RF kit being used was properly programmed.

If it does turn on briefly then shut off right away, pay attention to the parking light flashes. 

posté Dec 6, 2016 dans la catégorie Subaru par felipe sesnich (160 points)

2 Réponses

0 votes
Did you enable D2 option on bypass?
répondu Dec 6, 2016 par Edrice Iraola (1,090 points)
where exactly do i enable D2 option ?

 

how do i program oem key fob to remote start ?
0 votes
Please provide the service number of the actual Evo unit and not the Flashlink Updater-2 module. Is your vehicle a Push to Start or Regular Key vehicle?

 

Thank you,
répondu Dec 6, 2016 par J M (64,060 points)
sorry it's 38.2 function already enabled.

still doesn't remote start . when regular key is lock 3x to remotely start nothing happens . blue led doesn't flash at all.

only parking lights flash 3times after trying to remote starting by 3x lock with OEM key key fob remote

How do i get the oem remote ready mode to remote start car
did you had a 15 croostrek, with regular key .

how did you make work , how did you downgrade the firmware?
3 flash means ready mode not enabled. Cut the yellow loop on the evo f your vehicle is automatic transmission
Derek, when the car has been started remotely, the red and yellow lights are solid. When I press the Lock button on the factory remote, nothing happens (red and yellow continue to burn).
Felipe, in order to get it to start my 15 Crosstrek (regular key), I had to do the following:

1) In the software, toggle to Remote-Starter, and plug in the brain to the FLU.

2) Click on "Evo-One Updates"

3) In the firmware options, scroll to 1.19 and click select or "Recommended Update". Then click "Flash Update" at the bottom.

That should update the brain to the 1.19 firmware. From there, you set the options as they've been recommended.
...