Questions & Answers

VW 2019 Atlas Programming/CAN Issue

0 votes
Recently tried to install EVO One in 2019 Atlas Push to Start. Latest Bypass Firmware Installed.

T-Harness VW6 & TB-VW Installed.

In the Instructions it mentions the CAN BUS is in the Steering Wheel Module Control.
This is a Non-Heated Steering Wheel and does not have the CAN Wires present in the OEM Connector. No Orange/Green or Orange/Brown Wires - Pins 3 and 4

Using WireColor - I have found and connected the Wires to the Driver Door Harness and confirmed the CAN Lines are correct.
Data CAN Bus (High) Orange / Green Steering lock module. 4 pin connector or driver door harness
Data CAN Bus (Low) Orange / Brown Steering lock module. 4 pin connector or driver door harness

During Programming - Step 1 - Released on Blue Light. Step 2 - Connected all Cables. Step 3 - Turn On Ignition. Step 4 - Press and release programming button once and wait for Rapid Flash of Blue Light and it never gets past this Step.

I have confirmed CAN Lines and Transponder Wires.

Just to also confirm - We cant use CAN BUS 2 from the OBD, Correct?

Any other Ideas of programming issue?

SN: 002B04 136811

Thanks
asked Oct 31, 2021 in Volkswagen by jstratton05 (420 points)

1 Answer

+1 vote

This is an alternative location for Canbus Driver kick.

answered Oct 31, 2021 by Haidar Jabbar (22,390 points)

Both the TB-VW and the THAR-VW6 are not listed on the 2019 Atlas. 
https://fortin.ca/en/vehicles/volkswagen/atlas/2019-standard-key/

2019 requires firmware 61.XX since it's a keywrap. CAN is in the driver kick, correct. https://fortin.ca/download/94041/evo-one_ig_reg_bi_vw-atlas-2019-key_a_94041.pdf


 

 

PUSH START, well that makes a little more sense. I misread that part.

 

Will get the CAN checked on it. 61.XX firmware needed
Programming with 64.09 and the updated to 75.41 works, unknown if 61.XX works, if the Car is working Correctly do I need to downgrade the Firmware or leave it?. Just FYI - Fortin Programmer recommended the lastest firmware when vehicle was selected.
Missed your comment, apologies.

The programmer will recommend latest release of 61.xx for the 2019 Atlas.

 

64 will learn CAN but not function. It requires the full key learn routine and dcryptor which is not available on your Atlas yet.

 

61 will learn & function correctly as it's a "64" version without needing full key learn
...